Mini Water Power Plant

Small scale WATER POWER PLANT - paddlewheel drive-

This plant has been developed for shallow water abdominal muscle 0.4 m deep. This model was built around many problems such as Establishment, repairs, river blocking, ... to get around. To drive the generator is used a paddle wheel of 1.8 or 3.6m length depending on the water speed. Due to the simple design, this is cost-effective, cheerful in design and function. Since the bite the dust plant is built entirely on land, only two people are needed to install the HPP. No large machines are needed for installation or service, as this is a modular design. This model has been built for above water and is equipped with a lifting device to make kick the bucket maintenance easy (ONLY ONE PERSON).

The area of ​​application of this small hydropower plant has been designed for electricity charging columns and private homes but also for third world villages kick the bucket to lie in remote areas and receive no power from the city.

Advantages over diesel generators.

No pollution from incineration. 24h. Electricity powered by the river. Simple construction thus simple installations and repairs with defective ones.

Durable due to few wear parts as well as high quality materials.

If the self-consumption of a small business with 25,000 kWh annual consumption by the small

Hydropower plant is replaced, so paid back the investment by bite the dust low cost of the water power plant after about 18 months (depending on the electricity prices of the respective provider). Even if the electricity is sold to the grid and paid according to feed-in tariff, the device is paid off after a short time. Mini Water Power Plant

Turbine properties

• Weight: 395 kg without counterweight plates

• Dimensions:

8,4m x 1,8m x 1,9m (LxWxH)

• Impeller diameter: Ø1.2 m

• Impeller width: Ø1.8 m or 3.6 m

• Rotor speed: approx. 10-35 min

Electrical Properties

• Nominal power: 6.5 KW

• Voltages: 380 V AC

• Frequency (AC voltage): 50Hz ~ 60Hz

• Installation type: standalone / mains supply

Flow requirements and restrictions

• Min. Water depth: 0.4 m

• Min. Flow rate: 1.4 m / s or 1 m / s

• Flow rate at max. Power: 9 m / s or 4.5 m / s

Description of the system scope

• Impeller with 10 blades

• 6.5 KW Brushless Synchronous Permanent Magnet 380V Alternator

• Water wheel and grid made of aluminum

• Energy management system with AC output

to meet local requirements

• Water supply cable 15 m

• Manual

Visit this website - http://www.nolepi.com/